HomeWODRxHomeWODRx

Hack Squat Machine

Muscles
Quads, Glutes

The hack squat machine is an angled sled that runs on fixed rails. You stand on a platform with your back against a pad and the shoulder pads on top of your shoulders, then squat down and up as the sled slides along the rails. The fixed path and back support mean you don't have to balance the load, so you can focus on your legs. It works your quads most, with your glutes helping. Most hack squats are plate-loaded, with safety handles near your hands that lock the sled at the top. Some models also have adjustable safety stops lower on the rails. Where you place your feet on the platform changes the feel: lower puts more work on your quads, higher brings in more glutes. Check the placard on your machine for how its locks and stops work.

Set it up

Before you add plates, step in and set your back flat against the pad with the shoulder pads snug. Put your feet about shoulder width apart in the middle of the platform. If your model has lower safety stops, set them just below the depth you plan to reach. Push up slightly, release the safety handles, and do a slow test rep with no weight. Check that your heels stay down and your hips stay on the pad. Then load the plates evenly on both sides.

Common mistakes

  • Hips sliding off the pad at the bottomKeep your hips and lower back pressed into the pad. If they roll forward at the bottom, stop a little higher or move your feet slightly up the platform.
  • Heels lifting off the platformPush through your whole foot. If your heels rise, your feet are probably too low; move them up a little.
  • Slamming the knees into lockoutStand up to nearly straight legs with control. Snapping your knees straight under a heavy load adds stress to the joint and takes tension off your legs.
  • Loading too much too soonThe sled carries part of the weight, so the numbers can look bigger than your squat. Go by control and depth, not the plate count.

Safety

Know where the safety handles are and how to lock them before you load the machine. Re-engage them at the end of every set before you step out from under the pads. Load and unload plates evenly on both sides. Set the lower stops if your model has them. Start light while you learn the path of the sled. Muscle fatigue is normal; sharp pain in your knees, hips or lower back is not, so stop the set if you feel it. This guide is educational, not a substitute for in-person instruction; ask a staff member or trainer at your gym if you're ever unsure how to set up a machine. If you have a knee, hip, back or other injury, check with a doctor or physical therapist before using this machine.

Movements on this machine