HomeWODRxHomeWODRx

Hip Thrust Machine

Muscles
Glutes, Hamstrings

The hip thrust machine lets you do a Hip Thrust without setting up a barbell and bench. You sit with your upper back against a pad, a padded belt or lever arm across your hips, and your feet flat on a platform. You drive your hips up until your body is straight from shoulders to knees, then lower back down under control. Your glutes do most of the work, with your hamstrings helping. Because the machine holds the load in place, you don't have to balance a bar or roll it over your legs, and changing the weight is quick. Designs vary. Some models are plate-loaded, some use a weight stack, and some use a belt instead of a pad. Some have an adjustable back pad or foot platform. Check the placard on your machine before your first set, because how you get in, load it and adjust it depends on the model.

Set it up

Start with the machine empty or very light. Sit on the seat or floor platform and rest your upper back, just below your shoulder blades, against the back pad. Set the hip pad or belt across the crease of your hips, not on your stomach. Place your feet flat on the platform, about hip width apart. At the top of the rep your shins should be close to vertical; if they slant a lot, move your feet in or out. Do one slow test rep to check the pad stays in place, then add weight.

Common mistakes

  • Arching your lower back at the topStop when your body is straight from shoulders to knees. Keep your ribs down and your chin slightly tucked. If you lean back into an arch, your lower back takes over from your glutes.
  • Feet too close or too farAim for shins about vertical at the top. Feet too close and your quads take over; feet too far and you feel it mostly in your hamstrings.
  • Pushing through your toesDrive through your whole foot, with some weight in your heels. If your heels lift, move your feet a little closer.
  • Rushing the repsPause for a moment at the top and lower under control. Bouncing the weight off the bottom takes the work away from your glutes.

Safety

Learn how your model starts and stops before you load it. Set the pad or belt across your hips, not your stomach, and check any belt clips are fully closed. Load plates evenly on both sides. Lower the weight all the way down before you slide out of the machine. Start light while you learn the movement. Muscle fatigue is normal; sharp pain in your lower back, hips or knees is not, so stop the set if you feel it. This guide is educational, not a substitute for in-person instruction; ask a staff member or trainer at your gym if you're ever unsure how to set up a machine. If you have a back, hip, knee or other injury, check with a doctor or physical therapist before using this machine.

Movements on this machine