HomeWODRxHomeWODRx

Multi-Hip Machine

Muscles
Glutes, Hamstrings, Inner-thighs

The multi-hip machine works your hips in four directions, one leg at a time. You stand on a platform next to a padded arm that swings around a pivot at hip height. With the pad against one leg, you can push that leg back (hip extension), out to the side (abduction), in across your body (adduction), or forward and up (hip flexion). Your other leg stays on the platform for balance while you hold the handles. That makes it one machine for your glutes, outer hips, inner thighs and hip flexors. It is often used for balance and hip strength as well as glute training. Most models use a weight stack, and you rotate the arm and move the pad to change the exercise. Some have a platform that moves up and down so your hip lines up with the pivot. Check the placard on your machine for how to set the arm for each direction.

Set it up

Pick the lightest weight to start. Stand on the platform and line up the hip of your working leg with the machine's pivot point; raise or lower the platform if your model allows it. Rotate the arm to the start position for the direction you want and place the pad just above your knee, on the side you'll push from (back of the thigh to push back, outside to push out, inside to pull in, front to lift up). Stand tall, hold the handles and do a slow test rep. Then set the weight. Repeat the setup for the other leg.

Common mistakes

  • Hip not lined up with the pivotMatch the height of your hip joint to the machine's pivot. If they don't line up, the pad slides along your leg and the movement feels awkward.
  • Leaning your body to move the legKeep your torso tall and still. If you lean forward, back or sideways to move the pad, the weight is too heavy.
  • Swinging the legMove the pad slowly in both directions. Letting the weight swing back fast takes the work off your hips.
  • Pushing past your rangeMove only as far as you can without your lower back arching or your hips twisting. A small, controlled range is fine.

Safety

Hold the handles the whole set, because you're standing on one leg. Set the arm and pad with the weight resting on the stack, not mid-rep. Keep your standing foot flat and centered on the platform. Let the weight settle back onto the stack before you step off or change direction. Start light, since each direction uses different muscles and some are much weaker than others. Muscle fatigue is normal; sharp pain in your hips, groin, knees or lower back is not, so stop the set if you feel it. This guide is educational, not a substitute for in-person instruction; ask a staff member or trainer at your gym if you're ever unsure how to set up a machine. If you have a hip, knee, back or other injury, check with a doctor or physical therapist before using this machine.

Movements on this machine